Little Yarra & Latrobe River Catchment Summits

The week leading up to this weekend (14th & 15th of May) had been quite wet. The weekend itself was looking OK with Saturday being the pick of the days. A good opportunity to pick up some local summits, last activated Australia Day 2015 marked by an unexpected incident near Hyde Hill.
Following the same route as previous, I headed out through Wandin and Yarra Junction along the Warburton Hwy. Progress on the Warburton Hwy in the early morning was quite good but be warned. There are numerous traffic speed restrictions through the town ships and beyond that can make the going quite slow. Also a magnet for traffic cameras.
Turn off at the Old Warburton Hwy between Yarra Junction and Wesburn then look out for the Mount Bride Road, if heading east, located on a left hand bend from the Old Warburton Hwy. A short distance up the road is Burns Rd (seasonally closed). In winter you will not proceed past the gate but other times there is access to the old fire trail that heads along the Mt. Bride divide. In the dry this short section of Burns Rd would be trafficable in a 2WD but not this day, being very sloppy in the dip past the gate. There is adequate space to park a vehicle adjacent to where the Mt. Bride trail heads off to the east.

 

VK3/VC-009, Mt Bride – 898m, 4 Points20160514_102859[1]

Activation time 26 minutes.
Good phone access.
I was set up & operational just prior to my alert time and promptly had VK2GAZ, VK7CW, VK3ARH & VK2IO in the log on 40m CW and VK3PF on 80m CW inside of 10 minutes. Not great Near Vertical Incident Sky Wave propagation. Struggled with a XMode contact with Rik VK3EQ/P at Warragul and VK1MA – both on 40 metres SSB (15 minutes for these last two phone contacts shows just how good CW can be in patchy conditions!)
Packed up prior to UTC roll over and headed towards the next one.

VK3/VC-011, Britannia Range – 815m, 4 Points

Activation time 23 minutes.
Good phone access.
20160514_122650[1]Last time I was able to drive right up close to the activation zone & I was hoping to do the same this time. If it had been dry it would have been easy, in the still damp conditions it was anything but. I had already deflated the tyres when I hit the Britannia Range Track a little further south off the Mt. Bride Rd. It looked (and was) greasy – the surface being wet clay. Compressor was on and the front and rear diff locks soon engaged. An interesting ride part way up. Being solo, I abandoned the idea of driving up all the way when I got to the last little incline that looked nasty. Was able to turn around and park off the side of the track and walked the rest of the way.
I am not convinced the nominated height of the Britannia Range summit is correct? There is certainly a discrepancy between Forest Explore and the Garmin maps and the nominated height. Following up on my prior activation, I intended to investigate further!

It looks like a small section of Britannia Range Track enters the activation zone if the nominated height is 815 metres but both the aforementioned maps show the summit being above 820 metres & by Garmin 10 metre contours, above 830 metres but below 840 metres.

This means the Britannia Range Track is NOT inside the activation area; missing out by a whisker!
Now, GPS altimeters are far from accurate so I decided this time to head to the top.
There is a very overgrown 4×4 track that heads towards the summit off the Britannia Range Track. This stops in a small clearing above the 820 meter contour level. Proceeding further was a bit of a bush bash. I estimate that I got to within a couple of metres from the top (hard going) From this point I measured a 24 metre altitude change from where I had left the Britannia Range Track and thus I estimate the summit to be at 839 metres.

Back to the clearing, now determined as definitely being inside the activation zone, I set up and got to work. With the time spent determining the activation zone plus the walk, a short activation was planned.
CW only, worked VK2GAZ / VK2FDU (Fists Down Under), VK2IO & VK3PF on 40 metres. Got Gerard VK2IO again on 20 metres and John ZL1BYZ on 15 metres.
Discovered that I had picked up some leeches on my bush bash. Not the most conducive thing to find whilst on the key! A few on my clothes and 3 puncture marks on my hip. Glad they did not get any lower down! These became large welts during the following week but all clear now!
To the next summit!
Very slippery on the way down. Had to stop for some vehicles coming up – going side ways!

VK3/VC-008, Hyde Hill – 902m, 6 Points

Activation time 14 minutes.
Phone coverage OK to patchy.

What a difference a year or so makes with logging regrowth! Last time I parked at the junction of Black Sands & Big Creek roads and headed up through moderate growth along logging access paths and up to the edge of the logging area that was inside the activation zone. This was not going to happen this time. Instead, I parked on Black Sands Rd right on the edge of the logging & forest boundary and followed the cut line up. This turned out to be reasonably simple with only a few detours required. Forest Explorer has the summit above the 900 metre contour, Garmin has it above 910 metres. I followed the cut line to above the 880 meter contour and set up.

20160514_140604[1]

Logging regrowth. Yuk!

Plenty of room for the doublet, following the cut line in a north / south line giving broadside radiation to the east and west.
Worked VK3PF, VK2IO, VK7CW, VK3YY on 40 metres CW and ZL1Byz, VK3AFW & VK6NU on 20 metres CW. Put out a few calls without spotting on 40 metres phone without a response.
Back down to the car and to the final summit, passing the scene of the rollover of last year when, I had contemplated, the possibility of a 4th summit before things happened!

VK3/VT-040, Spion Kopje – 896m, 4 Points

Activation time was actually 80 minutes although the log would indicate 32 minutes.
Good phone coverage.

Lots of logging activity in this area. Timber Harvesting Zones along Outlook Rd and Limberlost Rd. Roads can be closed at any time without notice.

20160514_154952[1]

Very windy up top!

Access is straight forward along the walking track. This starts off as a very overgrown vehicle track fro where the walking path diverges up to the south. The path as shown on Garmin V5 Topo map is quite accurate. It is identified with occasional blue and orange  tape tied to trees but does involve some dead reckoning and bush bashing.
This time I went right to the top where there is a large flat rock and small stone cairn. No issue with the activation zone here. Garmin mapping is consistent with the nominated summit height.
Strapped the squid pole to a short tree and got on air. Looks like the broadside antenna radiation was North east and south west so not ideal for Long Path to Europe!

Began with Rik VK3EQ/P and Mitch VK3XDM/P on Mt. Worth for 2 x 40 metre phone summit to summit contacts before working Ian VK5CZ/P on Hallet Hill north of Adelaide on 40 metres CW.
Worked the usual suspects on CW but this time including Rick VK4RF and a surprise from David VK3ANP near Wangaratta. Best contact was John VK6NU on 15 metres CW.
I could hear Mick 2E0YYY/P quite clearly on 20 metres phone and tried for some time for a contact. Signals peaked close to 06:00 hrs utc and, with time marching on, I packed up at 06:20 hrs.

The track back down was not as easy to follow as on the way up and I diverged too far to the west, using the GPS track to correct my travel so as to pick up the old 4WD track back to the car. Missing the 4WD track would not be a good thing. Vegetation is quite dense and lots of really big slippery rock inclines to fall from!
Met a fella from the logging area where I had parked the car. Not sure what he was up to but he was interested that I had been to the summit. Spion Kopje is Dutch African for Spy Rock.
Back at the car, I headed home via Limberlost Rd and past Mt. Beenak. Not sure if this was a great idea as it got me into Timber Harvesting Zones on the wrong side of some gates. In the end, one gate was simply a plastic fence which I drove over (as others had done) to get out. Good mapping and some local knowledge saved the day but some time was wasted in detours and was not so easy in the now dark conditions.
Home via Gembrook just before 7:00 pm local.

Winter is coming!

 

 

 

 

 

Advertisements
Categories: Uncategorized | Leave a comment

Post navigation

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

Create a free website or blog at WordPress.com.

%d bloggers like this: